Getting Started
Starter Kit
Controller Board
Electronic Module

1.Product Introduction

../../_images/Raindrop-1.png

Raindrop sensor is a device used to detect the falling of raindrops, which is commonly used in automotive, smart home, and meteorological fields. It can sense the presence of precipitation and trigger the corresponding operation or feedback.

The working principle of the raindrop sensor is to use the resistance between two electrodes to sense the landing of raindrops. When the raindrop falls to form a conductive path between the electrodes, the resistance value will change accordingly, and the sensor determines whether there is a raindrop by measuring the resistance change.

Application reference: This module can be used for car wiper, smart home and weather detection station.

2.Parameter Specification

Parameter Value//Description
Operating voltage 3.3V~5V
Operating temperature -25°C~+85°C
Output signal analog signal
Size 3.16cm*2.38cm
../../_images/Raindrop-5.jpg

3.Wiring Diagram

../../_images/Raindrop-2.png
Raindrop Sensor UNO
VCC 5V
GND GND
S Analog pin A0

4.Sample Code

1//www.acebott.com
2void setup() {
3  pinMode(A0, INPUT); // Set pin A0 as an input
4  Serial.begin(9600); }
5void loop() {
6  Serial.println(analogRead(A0)); // Read the state of pin A0 and print it to the serial monitor
7  delay(1000); 
8}

5.Test Result

After uploading the code to the controller board, open the serial port monitor of the Arduino IDE, set the baud rate to 9600, and switch to automatic scrolling mode.

Drop water on the module and check the value of the serial port monitor with and without water on the raindrop sensor. You can see that the more water on the raindrop sensor, the greater the value of the serial port monitor.

../../_images/Raindrop-3.png
../../_images/Raindrop-4.png

6.Related Resources

7.Get One Now

B2B Business: info@acebott.com

© Copyright ACEBOTT All Rights Reserved.

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.